Firmware
5
4
3
2
1
6
D
C
A
B
D
C
A
B
5
4
3
2
1
6
How to Update (Main MCU) 2/5
5. Set speed update and update the MCU.
1 Set speed of update.
Press the OK button.
1 Set speed of update. Set
Baud rate to 38400.
2 Update the MCU.
E.P.R=>Erase+Read
2 Update the MCU
Press the E.P.R … button
Click on "Open"
3
to open the File Selection window.
Select Intel Hex files (*.hex) in File Type.
If the following messages are displayed, shut the
update program down, and start the update again
from step 1.
Select the 9600 of the Board rate
then press the OK button
Press the OK button.
Press the Exit button.
Please wait for until this window
disappears.
6. Update Finished MAIN microcomputer.
7. Unplug the AC cord.
Disconnect the FFC cable.
Push the JIG’s RESET button during 1
sec.
Press the OK button.
V
SX-330
