iPod is not charged but operates
correctly
Check if the connection cable for iPod
shorted out (e.g., not caught in metal ob-
jects). After checking, turn the ignition switch
OFF and back ON or disconnect the iPod and
connect again.
The connected USB portable audio
player/USB memory consumes
more than 500 mA (maximum allow-
able current).
Check if the connection cable for iPod
shorted out (e.g., not caught in metal ob-
jects). After checking, turn the ignition switch
OFF and back ON or disconnect the iPod and
connect again.
Error has occurred when connect-
ing the iPod to this unit
Reconnect the iPod.
Turn the ignition switch to OFF, then to ACC
or ON.
Update the iPod version.
Understanding auto TA and EQ error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears, refer to the
table below to see what the problem is and the suggested method of correcting the problem. After
checking, try again.
Message
Cause
Action
Error. Please check MIC.
Microphone is not connected.
Plug the supplied microphone securely into
the jack.
Error. Please check front SP.
,
Error. Please check FL SP.
,
Error. Please check FR SP.
,
Error. Please check center SP.
,
Error. Please check rear SP.
,
Error. Please check RL SP.
,
Error. Please check RR SP.
,
Error. Please check subwoofer
The microphone cannot pick up the
measuring tone of a speaker.
!
Confirm that the speakers are connected
correctly.
!
Correct the input level setting of the power
amp connected to the speakers.
!
Set the microphone correctly.
Error. Please check noise.
The surrounding noise level is too
high.
!
Stop your car in a place that is as quiet as
possible, and switch off the engine, air condi-
tioner or heater.
!
Set the microphone correctly.
<
CRB2972-A/N
>89
Additional Information
En
89
Appendix
Additional
Information