Black plate (67,1)
<CRB2123-A/U>67
!
No audio is outputted if the center speaker
setting is
SML
or
LRG
and no center speaker
is installed.
!
Audio is heard only over the center speaker if
installed and the center speaker setting is
SML
or
LRG
.
Selecting a cross-over
frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to
SML
, you can select a fre-
quency, under which sounds are reproduced
through a
LRG
speaker or subwoofer.
1 Press A and hold until FRONT appears
in the display, then press A to select HPF.
After
FRONT
is displayed, press
A
until
HPF
appears in the display.
2 Press
m
or
n
to select the speaker
to be adjusted.
Each press of
m
or
n
selects the speaker
in the following order:
F
(front speakers)
C
(center speaker)
R
(rear speakers)
S
(subwoofer)
3 Press
r
or
q
to select cross-over fre-
quency for the selected speaker.
Each press of
r
or
q
selects cross-over fre-
quencies in the following order:
63
80
100
125
160
200
(Hz)
4 Press BAND to return to the playback
display.
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofer
s L.P.F. (low-pass
filter) and that of the
SML
speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to
OFF
and other
speakers are set to
LRG
or
OFF
.
Adjusting the speaker
output levels
You can readjust the speaker output levels
using a test tone while listening to music.
1 Press A and hold until FRONT appears
in the display, then press A to select FRT-L.
After
FRONT
is displayed, press
A
until
FRT-L
appears in the display.
2 Press
m
or
n
to select the speaker
to be adjusted.
Each press of
m
or
n
selects the speaker
in the following order:
FRT-L
(front speaker left)
CENT
(center
speaker)
FRT-R
(front speaker right)
RER-R
(rear speaker right)
RER-L
(rear speaker left)
SUB.W
(subwoofer)
#
You cannot select speakers whose size is set
at
OFF
.
3 Press
r
or
q
to adjust the speaker
output level.
Each press of
r
or
q
increases or de-
creases the speaker output level.
+10
10
is
displayed as the level is increased or de-
creased.
4 Press BAND to return to the playback
display.
Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
T TONE
. Both provide the same results.
Digital Signal Processor
En
67
Section
12
Digital
Signal
Proce
ssor
