Step 6: Wires Installation
Soldering all wiring is recommended. Securely tape and insulate all connections soldered.
・
・
Secure all wires neatly to hide and prevent wire pinch
.
1. +12 VDC ACC/IGN - Locate the +12 VDC (ACC/IGN) and connect the red wire from the Main harness.
2. Chassis Ground (Black) - Connect the black wire from the Main harness to chassis ground.
3. +12 VDC reverse signal (Green) - Locate the +12 VDC reverse signal (reverse light or other location)
and connect the green wire from the Main harness.
4. Orange Right-Turn signal Trigger - Locate the +12 VDC Isolated turn signal and connect the Right
(Orange) wire from the Main harness.
5. Pink Left-Turn Signal Trigger - Locate the +12 VDC Isolated turn signal and connect the Left (Pink)
wire from the Main harness.
6. Connect the Main harness into the sensors.
7. Make all the appropriate connections (LED’s, Speaker, sensors) on the Main harness.
8.
9. Test the system’s operation, ensuring that all features operate according to this manual. After
operation is tested, finalize connections and secure wires.
Connect the negative terminal of the battery to the vehicle.
-14-
Fig 24
When installing the GPS Antenna, make sure it is not obstructed by any panels inside the vehicle
(see Fig 24).
Step 5: GPS Antenna Installation
E
n
g
li
s
h
