Installation Guide
Do not install the LED Indicators where it may (i) obstruct the driver's vision, (ii) impair the
performance of any of the vehicle's operating systems or safety features, including air bags or
hazard lamp buttons or (iii) impair the driver's ability to safety operate the vehicle.
Never install this product in front of or next to the place in the dashboard, door, or pillar from
which one of your vehicle's airbags would deploy. Please refer to the vehicle's owner's manual for
reference to the deployment area of the airbags.
Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain
exposed.
Make sure that the cables and wires will not interfere with or become caught in any of the
vehicle's moving parts, especially brake, doors, or any of the vehicle's controls.
If the wiring of this unit is located under a front seat, make sure it does not obstruct seat movement.
Route all leads and cords carefully around the sliding mechanism so they do not get caught or
pinched in the mechanism and cause a short circuit.
Do not shorten any leads. If you do, the protection circuit (fuse holder, fuse resistor or filter, etc.)
may fail to work properly.
When replacing the fuse, be sure to use a fuse only of the rating prescribed on this product.
Use only the parts included with the unit to ensure proper installation. The use of unauthorized
parts can cause malfunctions.
Never feed power to other electronic products by cutting the insulation of the power supply lead of
this product and tapping into the lead. The current capacity of the lead will be exceeded, causing
overheating.
Use this unit with a 12-volt battery and negative grounding only. Failure to do so may result in a fire
or malfunction.
Disconnect the negative terminal of the battery before installation.
Secure the wiring with cable clamps or adhesive tape. Wrap adhesive tape around wiring that comes
into contact with metal parts to protect the wiring.
Do not perform installation in rain or fog.
・
For
professional installation only by personnel with specialized training and experience in mobile
electronics.
・
・
・
・
・
・
・
・
・
・
・
The graphical symbol placed on the product means direct current.
・
・
・
WARNING
-10-
CAUTION
Ensure that the connector
is inserted correctly and
according to the corresponding label and the
arrow marks of the wire connector at
the connection point. When connecting, ensure
that
the
KEY
or
raised
area
of
the
connector
mates
with
the
opposite
connector. Do
not
force
any
connection
and
ensure
that
the
connector
mates
properly.
To
avoid
any
damage
to
the
connectors,
align
the
arrows
on
each
of
the
corresponding
items, then
firmly
press
connectors
together
to
ensure
a
good
connection.
Failure
to
properly
install
and
connect
the
system
components
may
cause
damage
to
the
product
and
operation
of
the
system.
・
・
E
n
g
li
s
h
