14
PRA-BD11 / PRA-BD12
En
Installation
E
e
f
F
A
E
PRA-BD12 output board connections
÷
Connect the 4-pin cable (L) already connected to connector
E
to connector
e
.
Secure the 4-pin cable (L) with a cable clamp before routing it.
Note:
The FFC cable (L) will be connected to the output board (connector
f
) in Step 11
3
. Do
not make the connection in this step.
PRA-BD12
output board
4-pin cable (L)
FFC cable (L)
Do not make the
connection now.
Cable clamp
10. Mount the rear bridge removed in Step 4 on the DVD recorder.
÷
Insert the rear bridge below the arms
4
in the PRA-BD11 input board and the PRA-
BD12 output board. Locate the rear bridge so that tabs
3
in the DVD recorder enter
the square holes
2
(one each on the right and left side) in the bridge. Use the four
screws
1
removed in Step 4 to secure the bridge. Install the four screws in the
following order:
a
,
b
,
c
,
d
.
Notes:
÷
Route the 4-pin cable connected to connector
A
and
E
underneath the rear bridge.
÷
Place the arms
4
of the PRA-BD11 input board and the PRA-BD12 output board on
top of the rear bridge.
PRA-BD12 output board
PRA-BD11 input board
FFC cable (L)
Rear bridge
