3
English
English
NOTE:
÷
When the display is to be moved after speaker
installation, do not hold the display by the speakers. Hold
the bottom of the display to move it.
÷
The grille nets are designed to protect the speakers,
however excessive force (such as pushing on, or insert-
ing objects between the grille nets) may result in dam-
age.
INSTALLATION ON THE PLASMA
DISPLAY
Perform installation according to the following steps
1
to
2
.
1
Attach the mounting fittings to the
speakers.
The illustration shows the right speaker.
For top side
Mounting plate
Flat countersunk
head screw
2
Attach the speakers to the display.
Install the unit marked "RIGHT" on the right side of the display.
Hexagon socket
head screw
Plasma display
Install the unit marked "LEFT" on the left side of the display.
For bottom
Hexagon socket
head screw
1
To attach the speakers to the display, start by placing the
upper screw where indicated, tightening until there is a
small space of about 5mm between the head of the screw
and the display.
2
Check the rear of the speakers for the LEFT and RIGHT
indicators to make sure you are attaching the correct
speaker to the corresponding right or left side. Make sure
the UP mark is pointing up, and then attach the speaker
by fitting the upper mounting over the head of the screw
and sliding down until snug.
3
Affix the lower fitting to the display and tighten the screw
about halfway.
4
Adjust the position so that the gap between the speaker
and the display is uniform, and then tighten the screws
firmly.
1
The top side fittings are dif-
ferent for the right and the
left side, and they must be
matched correctly.
2
Install the mounting fittings
with bolts at the positions
shown in the figure on the
left.
Plasma display
