Pioneer MVH-7300, Operation Manual

Page: 31 / 52

Notes
!
If SPEANA (spectrum analyzer) is selected,
the spectrum analyzer will be displayed in-
stead of Source image display or Artwork dis-
play.
!
If you select
USB
,
SD
as the source, you can-
not select Slide Show .
Customizing the illumination color
1 Use M.C. to select Color Setting in the
Appearance (Illumination color).
Refer to Appearance (screen/illumination
color) on the previous page.
2 Use M.C. to customize the color.
Turn for fine tuning. Push left or right to adjust
the next color.
3 Press M.C. to store the customized color
in the memory.
The illumination color will be switched to the
customized color.
Initial Settings
1 Press and hold SRC/OFF until the unit
turns off.
2 Press M.C. to display the initial setting
menu.
3 Turn M.C. to select the initial setting.
After selecting, perform the following proce-
dures to set the initial setting.
FM step (FM tuning step)
Normally, the FM tuning step employed by seek tun-
ing is 50 kHz. When AF or TA is on, the tuning step
automatically changes to 100 kHz. It may be prefer-
able to set the tuning step to 50 kHz when AF is on.
1
Press M.C. to display the setting mode.
2
Turn M.C. to select the FM tuning step.
100kHz (100 kHz)
—
50kHz (50 kHz)
3
Press
M.C.
to confirm the selection.
Auto PI
(auto PI seek)
The unit can automatically search for a different sta-
tion with the same programming, even during preset
recall.
1
Press M.C. to turn Auto PI seek on or off.
A-EQ Measurement (auto-equalizing)
The auto-equalizer is an equalizer curve created by
auto EQ (refer to
Auto EQ (auto-equalizing) on the next
page).
You can turn the auto-equalizer on or off.
Rear Speaker (rear output and subwoofer setting)
En
31
Section
03
Operating
this
unit
Operating this unit