Pioneer KURO PDP-LX508D, Service Manual

Page: 73 / 175

PDP-LX5080D
73
5 6 7 8
5 6
7
8
C
D
F
A
B
E
If the HD AV Converter is connected, check if it is connected
properly, as shown in the figure below.
(For details, refer to "Selecting the HD AV Converter" and
"HD AV Converter mode" in the Operating instructions.)
Check that the following conditions are met:
• The HD AV Converter must be connected to the INPUT 4
connector of the PDP.
• The HD AV Converter must be connected between the
PDP and a DVD recorder/BD player, as shown in the
figure
above.
• The AV device, such as an AV amplifier, and the HD AV
Converter are not connected simultaneously.
• The HDMI Control function must be activated on the HD
AV Converter. (For details, refer to the instruction manual
of the HD AV Converter.)
Confirmation of the number of connected devices
Check that the number of connected devices does not
exceed the maximum number for guaranteed operations.
Confirmation of settings
Check that the settings for the HDMI Control function are
properly made. (For details, refer to "Setting the HDMI
Control" in the Operating instructions.)
Check that the following conditions are met:
• "Input Setting" on the HDMI Control Setting menu must
be set to the same input as that to which the equipment
that supports the HDMI Control function is connected.
• When the HD AV Converter is connected, "HD AV
Converter" on the HDMI Control Setting menu must be
set to Enable.
• When Power Off Control, Power-On Ready, or Hold
Sound Status are to be used, their settings must be On.
• When the HD AV Converter is connected, the HDMI
Control switch on the rear panel of the HD AV Converter
must be set to ON. The HDMI Control indicator on the
front panel of the HD AV Converter will light in green
when HDMI Control is enabled. (The HDMI Control
indicator's lighting in green means HDMI Control is
possible.)
Equipment
Maximum
Number
DVD recorder 2
BD player 2
AV System 1 (
∗
1)
HD AV Converter 1 (
∗
1)
(
∗
1) Operation with either an AV device (AV amplifier, etc.) or the
HD AV Converter is guaranteed. If both are connected, their
operations are not guaranteed.
Check that the following conditions are met:
• The connected equipment must support the HDMI
Control
function.
• The equipment must be connected to the INPUT
connector that has been selected in "Input Setting" on
the HDMI Control Setting menu.
• The connections must be made properly, as shown in the
above figures (in a case where an AV device, such as an
AV amplifier, and a DVD recorder/BD player are
connected, in a case where only a DVD recorder/BD
player is connected, and in a case where an AV device,
such as an AV amplifier, which does not support
HDMI-CEC, is connected).
• When an AV device that supports the HDMI Control
function is connected, it must be connected between the
PDP and a DVD recorder/BD player.
• An AV device, such as an AV amplifier, and the HD AV
Converter must not be connected simultaneously.
• The HDMI Control function must be activated on the
connected equipment (DVD recorder, BD player, AV
device [AV amplifier, etc.], or the HD AV Converter).
(Refer to the instruction manual of the connected
equipment.)
Rear view
DVD recorder BD player
HDMI compliant cable
(HDMI cable having the
HDMI mark)
HDMI compliant cable
(HDMI cable having the
HDMI mark)
HD AV
Converter
Connect to INPUT 4