1 Compare the FM tuner volume level
with the level of the source you wish to ad-
just.
2Press AUDIO and then press NEXT to
display SLA.
Press
NEXT
until
SLA
appears.
#
SLA
is not displayed when you select FM
tuner as the source.
3 Press SLA to select the SLA mode.
4 Press
a
or
b
to adjust the source vo-
lume.
Each press of
a
or
b
increases or decreases
the source volume.
+4
4
is displayed as the source volume is
increased or decreased.
Notes
!
Since the FM tuner volume is the control, it is
not possible to apply source level adjustments
to the FM tuner.
!
The AM tuner volume level can also be ad-
justed with source level adjustments.
!
The built-in CD player and the multi-CD player
are set to the same source level adjustment
volume automatically.
!
External unit 1 and external unit 2 are set to
the same source level adjustment volume
automatically.
Auto TA and EQ (auto-time
alignment and auto-
equalizing)
The auto-time alignment automatically ad-
justed the distance between each speaker and
the listening position.
The auto-equalizer automatically measures
the car interior acoustic characteristics, and
then creates the auto-equalizer curve based
on that information.
WARNING
To prevent accidents, never carry out auto TA and
EQ while driving. When this function measures
the car interior acoustic characteristics to create
an auto-equalizer curve, a loud measurement
tone (noise) may be output from the speakers.
CAUTION
!
Carrying out auto TA and EQ under the follow-
ing conditions may damage the speakers. Be
sure to check the conditions thoroughly be-
fore carrying out auto TA and EQ.
When speakers are incorrectly connected.
(e.g., When a rear speaker is connected to
a subwoofer output.)
When a speaker is connected to a power
amp delivering output higher than the
speaker
s maximum input power capabil-
ity.
!
If the microphone is placed in an unsuitable
position the measurement tone may become
loud and measurement may take a long time,
resulting in a drain on battery power. Be sure
to place the microphone in the specified loca-
tion.
Before operating the auto TA
and EQ function
!
Carry out auto TA and EQ in as quiet a
place as possible, with the car engine and
air conditioning switched off. Also cut
power to car phones or portable telephones
in the car, or remove them from the car be-
fore carrying out auto TA and EQ. Sounds
other than the measurement tone (sur-
rounding sounds, engine sound, tele-
phones ringing etc.) may prevent correct
Audio Adjustments
En
54
Section
11
