Note
You can match the clock to a time signal by
pressing
MULTI-CONTROL
.
!
If
00
to
29
, the minutes are rounded down.
(e.g.,
10:18
becomes
10:00
.)
!
If
30
to
59
, the minutes are rounded up. (e.g.,
10:36
becomes
11:00
.)
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
!
If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune
in the stations with manual tuning or use
seek tuning again.
1
Display the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Use MULTI-CONTROL to select FM STEP.
3
Press MULTI-CONTROL to select the FM
tuning step.
Pressing
MULTI-CONTROL
repeatedly will
switch the FM tuning step between 50 kHz
and 100 kHz. The selected FM tuning step will
appear in the display.
Note
The tuning step remains at 50 kHz during manual
tuning.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
kHz to 1 602 kHz allowable) to 10 kHz (530 kHz
to 1 640 kHz allowable).
1
Display the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Use MULTI-CONTROL to select
AM STEP.
3
Press MULTI-CONTROL to select the AM
tuning step.
Pressing
MULTI-CONTROL
repeatedly will
switch the AM tuning step between 9 kHz and
10 kHz. The selected AM tuning step will ap-
pear in the display.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source
on page 32.
1
Display the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Use MULTI-CONTROL to select AUX1/
AUX2.
3
Press MULTI-CONTROL to turn AUX1/
AUX2 on.
#
To turn AUX off, press
MULTI-CONTROL
again.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
’
s headlights are turned on. You
can turn the dimmer on or off.
1
Display the initial setting menu.
Refer to
Adjusting initial settings
on the pre-
vious page.
2
Use MULTI-CONTROL to select DIMMER.
Initial Settings
En
28
Section
04