Initial Settings
En
51
11
Section
English
Español
Deutsch
F
rançais
Italiano
Nederlands
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car’s headlights are turned on. You
can switch dimmer on or off.
1 Press
FUNCTION
to select
DIMMER
.
Press
FUNCTION
repeatedly until
DIMMER
appears in the display.
2 Select
DIMMER
on or off with
5
/
∞
.
Pressing
5
/
∞
will switch
DIMMER
between on
and off and that status will be displayed (e.g.,
DIMMER :ON
).
Switching the rear output setting
This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker or subwoofer connection. If you
switch the rear output setting to the subwoofer,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,
set the output setting to subwoofer.
• Even if you change this setting, there is no
output unless you switch the subwoofer out-
put on (refer to
Using subwoofer output
on
page 47).
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
1 Press
FUNCTION
to select
REAR SP
.
Press
FUNCTION
repeatedly until
REAR SP
appears in the display.
2 Select full-range speaker or subwoofer
with
2
/
3
.
Pressing
2
/
3
will switch between
REAR SP
:FUL
(full-range speaker) and
REAR SP :S/W
(subwoofer) and that status will be displayed.
Selecting the digital attenuator
When listening to a CD or other source on
which the recording level is high, setting the
equalizer curve level to high may result in distor-
tion. You can switch the digital attenuator to low
to reduce distortion.
• Sound quality is better at the high setting so
this setting is usually used.
1 Press
FUNCTION
to select
DIG.ATT
.
Press
FUNCTION
repeatedly until
DIG.ATT
appears in the display.
2 Select
DIG.ATT
high or low with
2
/
3
.
Pressing
2
/
3
will switch
DIG.ATT
between
high and low and that status will be displayed
(e.g.,
DIG.ATT :H
).
