39
VSX-1128-K
5
6
7
8
5
6
7
8
A
B
C
D
E
F
7. DISASSEMBLY
1. Discharging
(1) Unplug the power cord.
(2) Disconnect the 10P connector from CP403 of the AMP7 Assy between CN3 of the MAIN Assy.
(3) CB and –B terminal of the D7, using resistor leads with 47 - 100 ohms (2 W or higher), for discharging.
∗
Discharging time: 30 - 60 seconds, depending on the level of resistance.
(4) Check that the voltage between the +B and –B terminals is less than 1 V, using a tester.
∗
Be sure to connect the GND terminal of the tester to the chassis.
∗
If the voltage is still 1 V or higher, repeat Step (3).
[1] MAIN Assy Capacitor (C55, C5
8
)
[Procedures]
47 - 100 ohms
(2 W or higher)
C55
+B
–B
D7
CP403
C58
MAIN Assy
AMP7 Assy
47 - 100 ohms
(2 W or higher)
Note:
Even if the unit shown in the photos and illustrations in this manual may differ from your product, the procedures
described here are common.
Some connections of the housing wires or connectors may be tight. When disconnecting those wires or
connectors, be careful not to damage them.
(1) Unplug the power cord.
(2) Connect pins 14 (–30V) and pins 15 (GND) of the
CN311 on the CPU Assy,
using resistor leads with 47-100 ohms (2 W or higher),
for
discharging.
∗
Discharging time: 5 - 10 seconds, depending on the
level of resistance.
(3) Check that the voltage between the –30V terminal is less
than
1
V, using a tester.
∗
Be sure to connect the GND terminal of the tester to
the chassis.
∗
If the voltage is still 1 V or higher, repeat Step (2).
[2] FL-30 V Capacitor (MAIN Assy C101)
[Procedures]
CN311
CPU Assy
GND
−30V
