11
PREP
ARA
TION
PREP
ARA
TION
Before You Start
8 inches (20 cm)
lock switch
Touch pen
Receiver
Installing the Receiver
Please note:
• Do not place objects directly on top of this unit. This would prevent
proper heat dispersal.
• When installing in a rack, shelf, etc., be sure to leave more than 8
inches of space above the receiver.
Opening the Front Panel
To open the front panel push gently on the lower third of the panel with your
finger.
Change Battery !!
OK ?
SIZE AA, LR6
SIZE AA, LR6
Remote Control Cushions
Apply the cushions to the feet of the remote control as shown in the
diagram right.
Operating range of remote control unit
The area in which you can use the remote control to operate
the VSX-39TX is fairly large. To use, point the remote control
toward the remote sensor on the front panel of this unit
while within the range shown right.
Remote control may not function properly if:
• There are obstacles between the remote control and the
remote sensor.
• Direct sunlight or fluorescent light is shining onto the
remote sensor.
• The receiver located near a device emitting infrared rays.
• Operated simultaneously with another remote control
which uses infrared rays.
30
30
23 feet (7m)
Remote Control Battery Alarm
When the batteries get too weak to operate the remote control properly an alarm
will sound and a warning screen will appear on the remote. Change the batteries as
shown on the previous page.
The Touch Pen & Lock
The touch pen is located in the back right-hand corner of the
remote control. Take it out by sliding your finger along the bottom
right edge of the remote control and then grasping the pen with
thumb and forefinger.
The lock switch is located in the top right-hand corner on the back
of the remote control. When this switch is set to LOCK you can’t
use the buttons on the remote control. This is helpful to prevent
you from mistakenly pushing a button. For normal use keep the
switch set in USE.
