Pioneer DVR-210-S, Manual, Page: 54 / 73

SERVICE MODE
For service operations, use the GGF1381 remote control unit for service.
The Service-mode screens consist of nine mode screens, which are classified into categories as recording system and VR
playback system, and their subscreens.
• How to enter Service mode: Press the ESC th e n DISP keys in that order while no GUI is displayed. The first screen (version
information, etc.) shown below is displayed.
• How to exit Service mode : Press the ESC key.
• How to advance to the next Service-mode screen
: While the first screen is displayed, press directly one of the keys 1-9. For service, press keys
2, 4 or 5, as shown below.
• How to advance to a subscreen within the same Service-mode screen
: Press the DIG/ANA key . Pressing the DIG/ANA key repeatedly will change the subscreens
within the same Service-mode screen cyclically.
The Service-mode screens to be used for service are as follows:
1 = First screen: Version information, etc.
2 = Second screen: ATA/ATAPI debug screen (Writer data)
4 = Fourth screen: Error log for the VR recording system
5 = Fifth screen: Error log for the VR playback system
Note: After entering one of the Service-mode screens, if you wish to shift to another Service-mode screen, exit Service mode first,
then reenter Service mode and select your desired Service-mode screen.
DVR-310-S/KU/CA
SYSCON : 1.00
ComRev : 1.1036 $
FirmRev : 1.2560 $
AppRev : 1.3210 $
TUFLCON : 1.12 M OK
DRIVE : DVD-RW DVR-106 OK
1.01G
CBT0900720WL
OK
H D D : ----
DEVICE : PRISM=ES 2.0
REGION : 1
C :
∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
Description of Each Service-mode screen
• Subscreen: Result of error-rate measurement
ERR RATE : x.xe-x/
1
2
4
5
6
7
8
3
OK : OK (proper combination)
NG+ : Version of the tuner microcomputer too advanced
NG– : Version of the tuner microcomputer too old
OK : OK (proper combination)
NG+ : Version of the drive too advanced
NG– : Version of the drive too old
OK : Serial No. of the drive already registered
NG : Serial No. of the drive not registered
1
Model name/destination
2
Version of the recorder software
3
Revision No. of the system-control computer software
(Edition administration No. [from top to bottom, common
software, firmware, application software])
4
Version No. of the tuner microcomputer, Mask or
flash (M: Mask type, F: FLASH type)
5
Information on the built-in drive
(Model name, version No., serial No.)
6
Version No. of PRISM
7
Region No.
8
CPRM data (CPRM key No.)
While the first screen shown above is displayed, press the DIG/ANA key to enter the subscreen shown below.
Note: Each time the DIG/ANA key is pressed, the display changes between the first screen and its subscreen.
Note: Be sure to start playback after displaying this subscreen
to calculate the error rate
.
1. First screen (version information, etc.)
During playback in VR mode, the average error rate of the past 10 VOBUs is displayed, and during playback in DVD-Video or
Video mode, the average error rate of the past 256 sectors is displayed. During playback in VR mode, the rotation rate of the
drive (/: normal speed, no display = double speed) is also displayed.