Initial Settings
Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1
Press SRC/OFF and hold until the unit
turns off.
2
Press MULTI-CONTROL and hold until
the initial setting menu appears in the dis-
play.
3
Turn MULTI-CONTROL to select one of
the initial settings.
For Southeast Asian models
CLOCK SET
(clock)
—
FM STEP
(FM tuning
step)
—
AM STEP
(AM tuning step)
—
AUX1
(front AUX input setting)
—
AUX2
(rear RCA
input setting)
—
SCROLL
(ever scroll)
—
COLOR SYS
(DVD output signal setting)
—
V.OUT
(display connection)
For South American, Oceanian, Middle
East Asian, South African models
CLOCK SET
(clock)
—
FM STEP
(FM tuning
step)
—
AM STEP
(AM tuning step)
—
AUX
(auxiliary input)
—
SCROLL
(ever scroll)
—
COLOR SYS
(DVD output signal setting)
—
V.OUT
(display connection)
Use the following instructions to operate each
particular setting.
Notes
!
You can also select the function by pressing
FUNCTION
on the remote control.
!
To return to the previous display, press
DISP/BACK/SCRL
.
!
To cancel initial settings, press
BAND/ESC
.
!
When
V.OUT
is set to
ON
, you cannot switch
to
SCROLL
.
Setting the clock
Use these instructions to set the clock.
1
Use MULTI-CONTROL to select
CLOCK SET in the initial setting menu.
Refer to
Adjusting initial settings
on this page.
2
Press MULTI-CONTROL to display the
setting mode.
#
Press
DISP/BACK/SCRL
to return to the pre-
vious display.
3
Press MULTI-CONTROL to select the seg-
ment of the clock display you wish to set.
Each time you press
MULTI-CONTROL
, one
segment of the clock display is selected.
Hour
—
Minute
As you select segments of the clock display,
the selected segment blinks.
4
Turn MULTI-CONTROL to put a clock
right.
#
You can also perform the same operations by
pushing
MULTI-CONTROL
up or down.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
!
If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune
in the stations with manual tuning or use
seek tuning again.
1
Use MULTI-CONTROL to select FM STEP
in the initial setting menu.
Refer to
Adjusting initial settings
on this page.
2
Press MULTI-CONTROL to display the
setting mode.
#
Press
DISP/BACK/SCRL
to return to the pre-
vious display.
3
Turn MULTI-CONTROL to select the FM
tuning step.
Turning
MULTI-CONTROL
will switch the FM
tuning step between 50 kHz and 100 kHz. The
selected FM tuning step will appear in the dis-
play.
Operating this unit
En
35
Section
02
Operating
this
unit
