58
No sound from the DIGITAL OUT (optical or coaxial)
jacks.
The
[Digital Out]
menu is set to
[Off]
.
\
Set the
[Digital Out]
(
Audio 1
menu) to
[On]
(
page 29
).
Can't play DVD or Video CD discs loded
The player is in CD Mode.
\
Press CD mode and make sure that the
CD
MODE
button is not lit (
page 43
).
When recorded on a VCR or passed through an AV
selector, there is disturbance in the playback picture.
This is not a malfunction.
\
Due to the player’s copy protection circuits,
connection of this device through a VCR or an AV
selector may prevent recording or cause picture
problems.
Remote control operation is not possible.
The rear panel control input jack on the player is being
used.
\
Point the remote control at the component that
the player is connected to (
page 17
).
The remote control is too far from the player, or the
angle with the remote sensor is too wide.
\
Be sure to operate the remote from a location
within its operating range (
page 8
).
The batteries are exhausted.
\
Replace the exhausted batteries with all new
batteries (
page 8
).
Audio is not output or is distorted.
The Setup screen
Audio 1
menu
[96 kHz PCM Out]
setting is set to
[96 kHz]
. Digital output is prohibited
on some discs.
\
Either connect using the analog outputs, or set
[96kHz PCM Out]
in the
Audio 1
menu to
[96kHz
3
48 kHz]
(
pages 16, 28
).
The disc is dirty.
\
Refer to
‘Disc Care’
(
page 54
).
The connection plugs are not inserted fully into the
terminals or are not connected.
\
Check that all connection plugs are firmly inserted.
The connection plug or terminal is dirty.
\
Check that the plugs and terminals are wiped
clean of dirt, etc.
Audio cable connection is wrong.
\
Check to make sure that the audio cables are
connected correctly (
page 16
).
Connection is made to the stereo amplifier‘s PHONO
input terminal.
\
Change connection to any input terminal except
PHONO.
The pause mode is engaged.
\
Press
PLAY
3
or
PAUSE
8
to exit the pause
mode.
Stereo amplifier operation is incorrect.
\
Check input (CD, AUX, etc.) selector to determine
if it is selected for DVD playback.
The DVD or CD is recorded in DTS audio.
\
DTS audio is only output from the digital output
jacks. Connect the digital output on the player to
the digital input on a receiver or amplifier with a
built in DTS decoder to hear DTS audio.
Noticeable difference in DVD and CD volume.
DVDs and CDs use different recording methods.
\
This is not a malfunction.
Caution
Static electricity or other external influence may cause
malfunctioning of this unit. In this case, unplugging
the power cord and then re-plugging it in will usually
reset the unit for proper operation. If this does not
correct the problem, please consult your nearest
PIONEER service center.