DV-400V-S
35
5
7
8
5
6
7
8
C
D
F
A
B
E
7.2 DVD DECK SECTION
2. REMOVAL OF DVD DECK PARTS
2-1: TRAY (Refer to Fig. 2-1-A)
METHOD AT NO POWER SUPPLY)
Tray.
1. Set the Tray opened.
(Refer to the DISC REMOVAL
2. Unlock the 2 supports
1
and draw it while sagging the
Fig. 2-1-A
Tray
Push to Sag
Push to Sag
Loader Ass'y
1
NOTE
1. In case of the Tray installation, install them as the circled
section of Fig. 2-1-B so that the each markers are met.
2-2: TRAVERSE ASS'Y (Refer to Fig. 2-2-A)
.
3. Remove the Insulator (R) from the Loader Sub Ass'y.
4. Remove the Traverse Ass'y.
Fig. 2-2-A
Tray
Loader Ass'y
Fig. 2-1-B
Insulator (R)
NOTE
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the disassembly
is done. If the repair is needed except listed parts,
replace the DVD MECHA ASS'Y.
NOTE
1. In case of the Traverse Ass'y, install it from (1) to (4) in
2. In case of the Traverse Ass'y installation, hook the wire
order.
(Refer to Fig. 2-2-B)
on the Loader Ass'y as shown Fig. 2-2-C.
1
Traverse Ass'y
Fig. 2-2-B
Check Lock
Traverse Ass'y
Rack Loading
Loader Ass'y (Bottom Side)
Holder Traverse
Fig. 2-2-C
Loader Ass'y
Check Hook
Loading Belt
Loading Sub Ass'y
Gear Pulley
1
2-3: LOADING MOTOR PCB ASS'Y/ LOADING BELT
(Refer to Fig. 2-3-A)
1. Remove the Loading Belt.
2. Remove the screw
1
.
3. Remove the Loading Motor PCB Ass'y.
4. Remove the 2 screws
2
.
5. Remove the Loading Motor.
6. Remove the Gear Pulley.
Fig. 2-3-A
Loading Motor PCB Ass’y
• Screw Torque: 2.0
±
0.3kgf•cm
• Screw Torque: 2.5
±
0.3kgf•cm (Screw
1
)
• Screw Torque: 1.0
±
0.3kgf•cm (Screw
2
)
2
2
Loading Motor
2
2
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
