- 42 -
En
gl
ish
[Installation]
Indicates whether the inertial navigation is successfully
learned. If the learning is successful, [OK] will appear. If the
learning is not successful or due to failure after the
learning is successful, [NOK] will appear.
NOTE
If this product is not firmly fixed into place or the speed pulse wire
is not connected or properly connected, [NOK] is displayed due to
the learning failure.
[Speed Pulse]
The speed pulse value detected by this product is shown.
NOTE
Check that the speed pulse wire is properly connected if [0] is still
displayed while driving.
[Back Signal]
When the gearstick is shifted to “R” (reverse position), the
signal switches to [High] or [Low]. The signal displayed
varies depending on the vehicle.
[System Information]
Displaying and updating the firmware version.
CAUTION
•
The USB storage device for updating must contain only the
correct update file.
•
Never turn this product off, disconnect the USB storage device
while the firmware is being updated.
•
You can only update the firmware when the vehicle is stopped
and the handbrake is engaged.
1
Download the firmware update files into your
computer.
2
Connect a blank (formatted) USB storage device to
your computer then locate the correct update file and
copy it onto the USB storage device.
3
Connect the USB storage device to this product
(page 23).
4
Display the [System Settings] screen (page 40).
5
Touch [System Information].
6
Touch [Update].
New firmware version information is displayed.
7
Touch [Update].
Follow the on-screen instructions to finish updating the
firmware.
NOTES
•
This product will reset automatically after the firmware
update is completed if the update is successful.
•
If an error message appears on the screen, touch the
display and perform the above steps again.
Menu Item
Description
