2 Press Multi-Control to turn warning
tone on.
ON
appears in the display.
#
To turn warning tone off, press
Multi-Control
again.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Use Multi-Control to select AUX.
AUX
appears in the display.
2 Press Multi-Control to turn AUX on.
ON
appears in the display.
#
To turn AUX off, press
Multi-Control
again.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
s headlights are turned on. You
can turn the dimmer on or off.
1 Use Multi-Control to select Dimmer.
Dimmer
appears in the display.
2 Press Multi-Control to turn dimmer on.
ON
appears in the display.
#
To turn dimmer off, press
Multi-Control
again.
Adjusting the brightness
You can adjust the display brightness. Initially
this mode is set to 12.
1 Use Multi-Control to select Brightness.
Brightness
appears in the display.
2 Push Multi-Control left or right to ad-
just the brightness level.
Each pushing
Multi-Control
left or right in-
creases or decreases the brightness level.
0
15
is displayed as the level is increased or
decreased.
Setting the rear output and
subwoofer controller
This unit
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Rear SP :FULL
) or subwoofer
(
Rear SP :S/W
) connection. If you switch the
rear output setting to the
Rear SP :S/W
, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
Rear SP :FULL
). When rear out-
put is connected to full range speakers (when
Rear SP :FULL
is selected), you can connect
the RCA subwoofer output to a subwoofer. In
this case, you can select whether to use the
subwoofer controller
s (low pass filter, phase)
built-in
Preout :S/W
or the auxiliary
Preout :FULL
.
1 Use Multi-Control to select SW control.
SW control
appears in the display.
2 Press Multi-Control to switch the rear
output setting.
Pressing
Multi-Control
will switch between
Rear SP :FULL
(full-range speaker) and
Rear SP :S/W
(subwoofer) and that status will
be displayed.
#
When no subwoofer is connected to the rear
output, select
Rear SP :FULL
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
Rear SP :S/W
.
Initial Settings
En
55
English
Section
12