Adjusting initial settings
1
Initial settings lets you perform initial setup of
different settings for this unit.
1
Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press Multi-Control and hold until the
clock appears in the display.
3 Turn Multi-Control to select one of the
initial settings.
Turn
Multi-Control
clockwise to switch be-
tween the functions in the following order:
Clock
(clock)
Warning tone
(warning tone)
AUX
(auxiliary input)
Dimmer
(dimmer)
Brightness
(brightness)
SW control
(rear
output and subwoofer controller)
Mute
(tele-
phone muting/attenuation)
Demonstration
(feature demo)
Reverse mode
(reverse
mode)
Ever-scroll
(ever scroll)
Use the following instructions to operate each
particular setting.
#
To cancel initial settings, press
BAND
.
Setting the clock
Use these instructions to set the clock.
1 Use Multi-Control to select Clock.
Clock
appears in the display.
2 Push Multi-Control left or right to select
the segment of the clock display you wish
to set.
Pushing
Multi-Control
left or right will select
one segment of the clock display:
Hour
Minute
As you select segments of the clock display
the segment selected will blink.
3 Push Multi-Control up or down to set
the clock.
Pushing
Multi-Control
up will increase the
selected hour or minute. Pushing
Multi-Control
down will decrease the se-
lected hour or minute.
Notes
!
You can match the clock to a time signal by
pressing
Multi-Control
.
If the minute is
00
29
, the minutes are
rounded down. (e.g.,
10:18
becomes
10:00
.)
If the minute is
30
59
, the minutes are
rounded up. (e.g.,
10:36
becomes
11:00
.)
!
Even when the sources are off, the clock dis-
play appears on the display.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone will sound. You
can turn off the warning tone.
1 Use Multi-Control to select
Warning tone.
Warning tone
appears in the display.
Initial Settings
En
54
Section
12
