2 Press
c
or
d
to adjust the brightness
level.
Each press of
c
or
d
increases or decreases
the brightness level.
0
15
is displayed as the
level is increased or decreased.
Selectingthe illumination
color
This unit is equipped with two illumination col-
ors, green and red. You can select the desired
illumination color.
1 Press FUNCTION to select ILLUMI.
Press
FUNCTION
repeatedly until
ILLUMI
ap-
pears in the display.
2 Press
c
or
d
to select the desired illumi-
nation color.
Pressing
c
or
d
will switch
ILLUMI
between
red or green and that status will be displayed
(e.g.,
ILLUMI :GRN
)
Settingthe rear output and
subwoofer controller
This unit
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
REAR SP :FULL
) or subwoofer
(
REAR SP :S/W
) connection. If you switch the
rear output setting to the
REAR SP :S/W
, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
REAR SP :FULL
). When rear
output is connected to full range speakers
(when
REAR SP :FULL
is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controller
s (low pass filter,
phase) built-in
PREOUT:S/W
or the auxiliary
PREOUT:FULL
.
1 Press FUNCTION to select REAR SP.
Press
FUNCTION
repeatedly until
REAR SP
ap-
pears in the display.
2 Press
a
or
b
to switch the rear output
setting.
Pressing
a
or
b
will switch between
REAR SP :FULL
(full-range speaker) and
REAR SP :S/W
(subwoofer) and that status will
be displayed.
#
When no subwoofer is connected to the rear
output, select
REAR SP :FULL
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
REAR SP :S/W
.
#
When the rear output setting is
REAR SP :S/W
, you cannot change the subwoofer
controller.
3 Press
c
or
d
to switch the subwoofer
output or nonfading output (full-range
RCA output).
Pressing
c
or
d
will switch between
PREOUT:S/W
and
PREOUT:FULL
and that
status will be displayed.
Notes
!
Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to
Using nonfading output
on page 43)
or subwoofer output (refer to
Using subwoofer
output
on page 43) in the audio menu on.
!
If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.
!
Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
Initial Settings
En
48
Section
10
