Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1
Use MULTI-CONTROL to select AUTO PI.
2
Press MULTI-CONTROL to turn Auto PI
seek on.
#
To turn Auto PI seek off, press
MULTI-CONTROL
again.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1
Use MULTI-CONTROL to select
WARNING TONE.
2
Press MULTI-CONTROL to turn warning
tone on.
#
To turn warning tone off, press
MULTI-CONTROL
again.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source
on page 34.
1
Use MULTI-CONTROL to select AUX1/
AUX2.
2
Press MULTI-CONTROL to turn AUX1/
AUX2 on.
#
To turn AUX off, press
MULTI-CONTROL
again.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
’
s headlights are turned on. You
can turn the dimmer on or off.
1
Use MULTI-CONTROL to select DIMMER.
2
Press MULTI-CONTROL to turn dimmer
on.
#
To turn dimmer off, press
MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit
’
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
REAR SP :FULL
/
PREOUT :REAR
) or subwoofer
(
REAR SP :SUB W
/
PREOUT :SUB W
) connec-
tion. If you switch the rear output setting to
REAR SP :SUB W
, you can connect a rear
speaker lead directly to a subwoofer without
using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
REAR SP :FULL
). When rear
output is connected to full range speakers
(when
REAR SP :FULL
is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controller
’
s (low pass filter,
phase) built-in
PREOUT :SUB W
or the auxili-
ary
PREOUT :REAR
.
1
Use MULTI-CONTROL to select
SW CONTROL.
2
Press MULTI-CONTROL to display the
setting mode.
#
Press
BACK
to return to the previous display.
3
Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press
MULTI-CONTROL
repeatedly to switch
the segment in the following order:
REAR SP
(rear speaker setting)
—
PREOUT
(RCA output setting)
4
Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
Initial Settings
En
31
English
Section
04
