Pioneer DEH-4090MP, Owner'S Manual

Page: 15 / 34

Introduction of audio
adjustments
1 Press MULTI-CONTROL to display the
main menu.
2 Use MULTI-CONTROL to select AUDIO.
Turn to change the menu option. Press to se-
lect.
3 Turn MULTI-CONTROL to select the
audio function.
Turn
MULTI-CONTROL
to switch between the
audio functions in the following order.
FADER/BALANCE (balance adjustment)
—
PRESET EQUALIZER
(graphic equalizer recall)
—
EQ SETTING 1 (graphic equalizer adjust-
ment)
—
EQ SETTING 2 (graphic equalizer fine
adjustment)
—
LOUDNESS
(loudness)
—
SW SETTING 1 (subwoofer on/off setting)
—
SW SETTING 2 (subwoofer setting)
—
HPF
(high pass filter)
—
BASS BOOST
(bass boost)
—
SRC LV ADJUST (source level adjustment)
4 Press MULTI-CONTROL to display the
setting mode of each function.
#
Push MULTI-CONTROL left to display the
function selection menu.
#
Push and hold
MULTI-CONTROL
left to dis-
play the main menu.
5 Adjust the each function.
Notes
!
You can also select the audio function by
pressing
AUDIO on the remote control.
!
To return to the previous display, press BACK .
!
To return to the main menu, press and hold
BACK .
!
To return to the ordinary display, press
BAND/ESC
.
!
When the subwoofer controller setting is
PREOUT:REAR , you cannot switch to
SW SETTING 1
(subwoofer on/off setting).
(Refer to page 20.)
!
You can select the
SW SETTING 2
only when
subwoofer output is turned on in
SW SETTING 1 .
!
When selecting FM as the source, you cannot
switch to
SRC LV ADJUST .
!
If you do not operate functions within about
30 seconds, the display automatically returns
to the ordinary display.
Using balance adjustment
You can change the fader/balance setting so
that it can provide the ideal listening environ-
ment in all occupied seats.
1 Use MULTI-CONTROL to select
FADER/BALANCE.
2 Press MULTI-CONTROL to display the
setting mode.
3 Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press MULTI-CONTROL repeatedly to switch
between fader and balance.
4 Turn MULTI-CONTROL to adjust front/
rear speaker balance.
Front/rear speaker balance can be adjusted
between
FAD F15 and FAD R15 .
Left/right speaker balance can be adjusted be-
tween
BAL L15 and BAL R15 .
#
You can also perform the same operations by
pushing
MULTI-CONTROL
up or down.
#
FAD 0 is the proper setting when only two
speakers are used.
#
When the rear output setting is
REAR SP :SUB W , adjusting the front/rear speak-
er balance is not effective. Refer to Setting the
rear output and subwoofer controller on page
20.
Audio Adjustments
En
15
Section
03
Audio
Adjustments