Pioneer CS-A50, User Manual

Page: 12 / 16

11
Handset registration
Setting
1. Make sure the base unit is connected into the AC outlet and line
jack.
2. Press and hold the button on the base unit. After 3 seconds,
press the button on the handset, the unit will give you a
confirmation beep, which means that the code has been set and the
handset will show
on the LCD.
3. If you have more than one handset, press the button on
the handset until you get a beep and display . Continue the
same procedure, if you have the third handset. If not, release the
button from the base unit.
The button on the base unit should be kept pressing
during the whole procedure.
The base unit and the handset have been set
code already.
In standby mode, press button once, then the LCD will
show to indicate you enter the setting mode.
Press button, then button, and then the LCD will show
Enter the number (up to 4 digits) by keypad (you can press
button to delete the error digits) and press button
once more to confirm. A confirmation beep will be heard.
CH CODE
CH CODE
NOTE:
IMPORTANT NOTICE:
EDIT TRANS
EDIT TRANS 1
R EDIT TRANS
HS -1
HS -2
PROGRAM
AREA CODE.
Area code setting
Handset Settings
Reviewing the Caller ID list
Dialling the C aller ID numbers
1. Press or button, the LCD shows the total number of Caller ID
numbers andnewnumbers.( )
. Press or button to review the other caller numbers.
During the reviewing mode, press button to dialled out the number
showedonthe LCD.
If the Caller ID number exceeds 8 digits, you can dial the number as
above or in other4 ways a s follows.(e.g. thenumber is
)
s t
s t
ALL XX NEW XX
2
#
34567890123
Caller ID Operation
20
JOHN BULL
Press button to dial the number with the digit.
0 0
TALK