06
38
Troubleshooting
Incorrect operation is often mistaken for trouble or malfunction. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Inspect the other components and electrical appliances being used. If the
trouble cannot be rectified even after checking the points below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
Playback
Problem
Check
Remedy
• Disc does not play.
• Disc tray opens
automatically.
Is the disc one that is playable on
this player?
Check whether the disc is one that can
be played on this player (page 7).
Is the file one that is playable on this
player?
• Check whether the file is one that can
be played on this player (page 9).
• Check whether or not the file is
damaged.
Is the disc scratched?
It may not be possible to play scratched
discs.
Is the disc dirty?
Clean the disc (page 37).
Is there a piece of paper or sticker
attached to the disc?
The disc may be warped and unplayable.
Is the disc properly set in the disc
tray?
• Set the disc with the printed side facing
up.
• Set the disc properly in the depression
in the disc tray.
Is the region number correct?
See About region numbers on page 7 for
the region numbers of discs that can be
played on this player.
No picture is displayed
or the picture is not
displayed properly.
Is the video cable properly
connected?
•
Connect the cable properly according to
the connected devices (page 13).
• Insert the cable firmly and all the way in.
Is the video cable damaged?
If the cable is damaged, replace it with a
new one.
Is the input setting on the connected
TV or AV receiver or amplifier right?
Read the operating instructions of the
connected components and switch to the
proper input.
Is the output video resolution
properly set?
Use HDMI to switch to a resolution at
which the video and audio signals are
output
• Is the player connected with an
HDMI cable other than a High Speed
HDMI
®
/
™ cable (with a Standard
HDMI
®
/™ cable)?
• Are you using an HDMI cable with
built-in equalizer?
1080p or Deep Color video signals may
not be output properly, depending on the
HDMI cable being used or the player’s
settings. After this, if you wish to output
the video signals with 1080p or Deep
Color, connect the TV using a High
Speed HDMI
®
/
™ cable without built-in
equalizer, then reset the player using the
Setup Navigator.
Is a DVI device connected?
The picture may not be displayed
properly if a DVI device is connected.
Is HDMI Color Space properly set?
Change the HDMI Color Space setting.
Summary of Contents for BDP-3110
