Pioneer AVX-MG2037UC, Service Manual

Page: 124 / 140

AVX-MG2037ZF/XN/UC
A
B
C
D
1 2 3 4
1 2 3 4
124
15. While pressing the shaft holder in the direction
shown by the black arrow in the right figure, remove
the PU Unit together with the Screw Unit.
Note:
To assemble the PU Unit, insert the Spring on the PU
rear between the PU Unit and the Guide first.
Fig.11
4. Apply shorting solder to the PU flexible cable before
disconnecting it from the connector CN12.
5. Disconnect the flexible cable from the connector CN12,
and remove the flexible cable Holder.
6. Remove the washer and Arm. (Be careful not to lose
the spring B.)
7. Remove the screw, spring A, and Collar.
8. Remove the Carriage Mech. Assy.
Fig.9
9. Apply shorting solder to the PU flexible cable before
disconnecting it from the Connector.
10. Disconnect the PU flexible cable from the
Connector.
11. Move the PU Unit to the left side slightly by turning
the Gear.
12. Pull out the spindle motor Support Wheel Unit
upwards to remove it.
13. Remove the Spring.
14. Slide the holder to make it easier to remove the
Screw Unit.
Fig.10