En
g
lis
h
- 151 -
problem, contact your dealer or an
authorised Pioneer Station for
assistance.
Positioning is not possible due to
hardware error. Please consult your
dealer or local authorised service centre.
→
The location display is not possible due
to hardware failure.
– Contact your dealer or an authorised
Pioneer Station for assistance.
No GPS antenna. Check connection.
→
GPS reception is lost.
– Check the aerial connection. If the
message fails to disappear even after
the engine is switched off/on, contact
your dealer or an authorised Pioneer
Station for assistance.
GPS antenna problem detected. Contact
dealer or service center.
→
GPS aerial lead is short-circuited.
– Contact your dealer or an authorised
Pioneer Station for assistance.
Calibration will start, but may be
inaccurate without speed pulse.
→
The speed pulse sensor is not
connected correctly.
– Contact your dealer or an authorised
Pioneer Station for assistance.
Sensor error. Please contact your dealer
or Pioneer Service Center.
→
An error has occurred with the sensor.
– Contact your dealer or an authorised
Pioneer Station for assistance.
Detected unusual speed pulses.
→
The speed pulse cannot be detected
correctly.
– Contact your dealer or an authorised
Pioneer Station for assistance.
Detected changes in the installation
angle or position. The in-dash receiver is
updating the sensor learning data.
→
Changes in the installation angle or
position are detected.
– Wait until the sensor learning finishes.
Speed pulse wire is not connected. The
system will operate in simple hybrid
mode.
→
Speed pulse wire is not connected.
– The speed pulse cannot be detected if
the speed pulse wire is not connected
correctly.
Check Antenna
→
The aerial connection is incorrect or an
unusual voltage has been detected.
– Turn the ignition switch OFF and
connect the aerial correctly. After
connecting, turn back ON again.
Error-02-XX/FF-FF
→
The disc is dirty.
– Clean the disc.
→
The disc is scratched.
– Replace the disc.
→
The disc is loaded upside down.
– Check that the disc is loaded correctly.
→
There is an electrical or mechanical
error.
– Press the RESET button.
Different Region Disc
→
The disc does not have the same region
number as this product.
– Replace the DVD with one bearing the
correct region number.
DAB tuner
Disc
Z930DAB Z830DAB Z730DAB Z7330DAB