Pioneer AVIC-HD3, Service Manual

Page: 221 / 317

AVIC-Z1/UC
214
1 2 3 4
1 2 3 4
C
D
F
A
B
E
3-9(4-9). HDD shipping flag setting
• Set HDD to the shipping status. Contents of HDD will not be damaged.
• Push down "MAP" key, and HDD shipping flag setting (HDD mode change) will start.
• After setting HDD shipping flag, use [AV] key to go back to the main menu.
Displayed errors
<Clearing of HDD user area Error list>
Shown below are errors which occur when HDD user area is cleared.
Delete file not found
Atapi device error
Error
When no files or directory to be deleted are found, this will be displayed.
However, this is not an error as HDD has no files to delete.
This will be displayed in the case of errors other than those mentioned above.
Error factors
When something is wrong with the device, this will be displayed.
CRC error, UnCorrectable error When it fails in reading and writing data, this will be displayed.
It failed to find Drive. When no drive is specified or HDD driver cannot be opened, this will be displayed.
Drive format error When format command is not executed successfully, this will be displayed.
Displayed errors
<Clearing of Main Memory Error list>
Shown below are errors which occur when Main Memory (Clearing of SENSOR STUDY) is cleared.
CLEAR ONLY SENSOR STUDY OF HDD. GPS NONCONNECT.
It failed to clear SENSOR STUDY.
This is displayed when GPS is not connected (when GPS is out of order).
Error factors
This is displayed when SENSOR STUDY CLEAR COMMAND
does not work. (Both HDD and GPS cannot be cleared.)
It failed to communicate with GPS unit. This is displayed when time-out occurs while communicating with GPS unit.
Displayed errors
<Error list>
Shown below are errors that take place at the time of HDD shipping flag NG (HDD mode change NG).
Error codes are all decimal numbers.
It failed to open HDD device.
Parameter error of HDD mode change.
This error occurs because it fails to open HDD device.
Error factors
This error occurs because the parameter is incorrect. (Error code : 87)
It was refused to request HDD mode change. This error occurs because the parameter is incorrect. (Error code : 5)
It was timeout to request HDD mode change. This error occurs because the request take so long that timeout occurs.
(Error code : 1053)
It failed HDD mode change. [0x
********
] This is displayed when mode change fails to be executed.
[
********
] represents error codes value.
[Example]
• NG occurs because HDD is unconnected. (Error code : 55)