Pioneer AVIC-F940BT, Installation Manual

Page: 10 / 60

Connecting the power cord (1)
ISO connector
*1
*3
*2
*4
Speaker leads
White: Front left

White/black: Front left

Grey: Front right

Grey/black: Front right

Green: Rear left

or Subwoofer

(*5)
Green/black: Rear left

or Subwoofer

(*5)
Violet: Rear right

or Subwoofer

(*5)
Violet/black: Rear right

or Subwoofer

(*5)
Depending on the types of vehicles, the
function of *2 and *4 may be different. In this
case, be sure to connect *1 to *4 and *3 to *2
as shown in the figure.
Connect leads of the
same colour to each other.
Yellow
(*2)
Back-up
(or accessory)
Red (*4)
Accessory
(or back-up)
Yellow (*1)
To terminal supplied with
power regardless of ignition
switch position.
Red (*3)
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Note Notes
· When a subwoofer (*5) is connected to this
navigation system instead of a rear speaker, change
the rear output setting in the initial setting. (Refer to
Operation Manual.) The subwoofer output of this
navigation system is monaural.
· When using a subwoofer of 70 W (2
Ω
), be sure to
connect with violet and violet/black leads of this
navigation system. Do not connect anything with
green and green/black leads.
In some vehicles, the ISO connector may be divided
into two. In this case, be sure to connect to both
connectors.
Note
Engb
10
Section
02
Connecting the system