9
X:\print\Pioneer\19AJ\HIGH\19_High_EU_QRD3723(A5_Horizon)_INST\020Chapter_GB.fm
AVH-Z9200DAB
19_High_EU_QRD3723(A5_Horizon)
En
En
g
lish
Dashboard
4
Attach the trim ring.
Trim ring
Groove
Attach the trim ring with the side
with a groove facing downward.
1
Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw
holes are aligned with the screw holes
of the bracket, and tighten the screws at
three locations on each side.
Use either the truss head screws or flush
surface screws, depending on the shape
of the bracket’s screw holes.
Factory radio-mounting bracket
If the pawl interferes with
installation, you may bend it down
out of the way.
Dashboard or console
Truss head screw or flush surface
screw
Be sure to use the screws supplied
with this product.
CAUTION
Do not cut the GPS aerial lead to shorten it
or use an extension to make it longer.
Altering the aerial cable could result in a
short circuit or malfunction and
permanent damage to this product.
•
The aerial should be installed on a level
surface where radio waves will be
Installation using the screw
holes on the side of this
product
Installing the GPS
aerial
Installation notes
blocked as little as possible. Radio waves
cannot be received by the aerial if
reception from the satellite is blocked.
Dashboard
Rear shelf
•
When installing the GPS aerial inside the
vehicle, be sure to use the metal sheet
provided with your system. If this is not
used, the reception sensitivity will be
poor.
•
Do not cut the accessory metal sheet.
This would reduce the sensitivity of the
GPS aerial.
•
Take care not to pull the aerial lead when
removing the GPS aerial. The lead may
become detached.
•
Do not paint the GPS aerial, as this may
affect its performance.
