62
DDJ-RZX
1
2
3
4
A
B
C
D
E
F
1
2
3
4
[Picture transit]
By pressing the eithet BACK button of right and left DECK, exit the mode, and returns to service mode
(
1
-1: Adjustment information mode), and then displays the result. (The LCD which is Not complied with or not carried out to
the last test is displayed as " - ", and the LCD which is completed normally is displayed as " 0 ". Besides, the upper right side
square button of LCD blinks for caution if there is a LCD which is not completed normally.
When the each LCD is OK on four points (all 12 points because it is composed of 3 LCDs), the mode returns to service mode
(
1
-1: Adjustment information mode) automatically.
The 12 points is able to operate by touching from any points.
The result is cleared (reset) on the service mode (
1
-3: Factory reset mode).
Press
(In case of OK)
1
-9: Touch panel checking mode
When execuiting yhe service mode (
1
-1: Adjustment information mode), press the right and left VIEW and SINGLE buttons
on center LCD simultaneously, and enters to the touch panel checking mode.
If touch panel checking has already done, it is necessary to clear the result by the service mode (
1
-3: Factory reset mode)
before performing the touch panel checking. When performing the factory reset, note the user settings according to the
“8.3 ITEMS FOR WHICH USER SETTINGS ARE AVAILABLE” .
By returning to service mode (
1
-1: Adjustment information mode) and then displays the result, it is possible to check the touch
panel checking has already done or not. The LCD which is completed normally is displayed as “0” .
The judgement OK is identified by the test result is positioned inside the picture area for judgement.
Press
(In case of OK)
Press
(In case of OK)
Press
(In case of OK)
The touch panel calibration is completed by touching the center " + " mark displayed in order, and storing the calibration
value by pressing all 4 points.
(Returns to service mode (
1
-1: Adjustment information mode), and displays the result).
And when the BACK button is pressed on the way, the calibration value is not stored and the touch panel calibration mode is
finished, (Returns to service mode (
1
-1: Adjustment information mode), and displays the result).
And the lower right side square button of LCD blinks for caution in this case.
1
-10: Touch panel calibration mode
TOUCH DISPLAY CALIBRATION
Touch the center of each of the "+" marks.
