Step 1: This shows a wrapped swing set kit as it will
arrive to your destination.
Step 2: Start by cutting
open plastic shrink wrap;
slice all way around the
kit and then vertically at
each corner to remove
plastic.
Step 3: Remove all the parts from the kit and systematically lay them out on the
ground surface. Remove plastic wrapping from all parts.
Step 4: The last part in
the kit is the floor of the
play set; it may be
necessary to remove
some screws that attach
the floor to the shipping
pallet.
Step 5: To start construc-
tion of your play set find
the four 2 x 6's that
make up the base. Two
are 72" and two are
86-1/4" long.
Step 6: At the specific location
where you intend to erect your
play set, arrange the four pieces
as follows: the 72” piece with six
holes will be placed to the front,
the 72” piece with four holes will
be placed to the back, and the
two 86-1/4” pieces with no holes
will make up the sides of the
base. The 5/8” holes in the mid-
section of the front piece must
be left of center, to line up with
the holes in the floor.
© Pinnacle Play Systems
page 3
