Pinnacle MovieBox DV, Quick Start Manual

Page: 12 / 78

8
Pinnacle MovieBox DV
E
nglis
h
Technical Data
K
EY
F
EATURES
ΠRealtime video converter between DV (Blue book SD 625-50, SD 525-
60) video compression format and analog video (both directions, half-
duplex)
ΠCCIR 601 format, NTSC/PAL/SECAM: 50/60 fields, 720x480 /
720x576, YUV 4:1:1 / 4:2:0 chroma sub sampling, SECAM support on
analog input only.
Œ
Video standard auto detection on analog inputs
Œ
Analog outputs use same TV standard as active input (PAL, if
SECAM is used on input).
Π25 MBits/sec standard DV data rate for both directions.
Œ
Video standard auto detection on digital inputs
Œ
Digital output uses same video standard as active input
ΠStand-alone functionality (accessible w/ any DV enabled device):
Œ
DV-to-Analog
Œ
Analog-to-DV w/ default values for audio format and video settings
Œ
Manual selection of video and audio source (via Mode Select
button). Automatic selection depending on available signal when box
is switched on or resetted
ΠSupports locked DV In/Out audio formats
Œ
32 kHz, 12 Bit, stereo ( optional : channel A/B or C/D selectable)
Œ
48 kHz, 16 Bit, stereo
ΠSupports unlocked DV In/Out audio formats
Œ
32 kHz, 16 Bit, stereo
Œ
44,1 kHz, 16 Bit, stereo
ΠA/V connectors (input and output, one set each):
Œ
Composite and S-Video
Œ
Stereo audio, unbalanced
ΠUser Interface / Controls
Œ
One green LED for each video source (Y/C, Composite, DV ”port
A”, DV ”port B”) – the two LEDs used for the DV ports are both
enabled if DV is selected as input (via Mode Select button), the two
LEDs are both ”off” if S-video or Composite are used as input;
button for mode selection (everytime the Mode Select button is
pressed, the ”next” mode will be used: Composite, S-video, DV,
Composite, S-video, DV, … ), button for hardware reset
Œ
One green LED for power indication
ΠPlug&Play installation (no need to install any software for access to
basic functionality)