Pinnacle EDGE EX33, Nstallation Instructions

Page: 10 / 25

End Trim
(2 per section)
Quick Connects
#8-32x1-1/8” Bolt
12655 E. 42nd Ave. #50 Denver, CO 80239 Phone: 303.322.5570 Fax: 303.322.5568 www.pinnacle-ltg.com
1. Install End Trim after louver installation.
Two (2) per 4’ section
Three (3) per 8’ section
Four (4) per 12’ section
1. Install first fixture with two (2) mounting points.
2. Subsequent fixtures use one (1) mount.
3. Install two (2) #8-32 bolt into each fixture as shown.
4. Raise adjoining fixture and slip bolt heads through key-hole slot.
5. Attach mounting to fixture as previously shown.
6. Make necessary wiring connections between fixtures ensuring all wires are
properly matched.
7. Tighten the previously installed #8-32x1-1/8” (1/2 turn past hand tight) to com-
plete joining and create ground.
Step 5:
Joining Fixtures
1. Install end plates prior to lens/louver installation.
2. Place against end of fixture and secure using two (2) #6-32
nuts.
Step 6:
Finishing
EX33 Louver End Trim
EDGE
EX33
EX44
T5/T5HO/T8/LED
AC - to - Fixture Mount
© 2017 Pinnacle Architectural Lighting
10 of 25
EdgeEX33_44_Booklet_January 2017
1. This product must be installed in accordance with applicable installation and electrical codes by a professional familiar with the
construction and operation of the product.
2. Minimum 90ºC supply conductors
3. All electrical connections must be performed by a certified electrician to applicable local and national electrical codes.
4. Fixtures must be mounted directly to structure.
5. The holding strength of AC cables cannot be guaranteed if the cables are damaged in any way.
Return to
Main Menu