VX/ VXBR CFL INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
MOUNTING
Fixture should be located on wall or ceiling and not be
recessed. Use the
Housing Template
to match the recessed
or surface mount
Junction Box
(not supplied) or use the
Housing
to make electrical connections. Fixture cannot be
mounted upside down in wet locations.
For more secure
installation, lag bolt ballast box to mounting surface.
1.
Loosen
Housing
Screws
from
Front of Housing.
2.
Prepare
Back of Housing
for use by knocking out the
appropriate mounting holes.
3.
Seal all gaps between ceiling and fixture with
weatherproof silicone sealant. (Be sure to use the
Gasket
supplied.)
4.
Fixture may be wired through back conduit entrance or
either side conduit entrance for surface mounting.
5.
Connect wires as shown in wiring section. The
Back of
Housing
has a
Tether Cable
and the
Front of Housing
has a
Loop
for hanging the fixture during wiring.
6.
Reattach the
Front & Back
Housing
. Be sure the original
Gasket seals properly. Tighten
Housing Screws
.
7.
Install the lamp, globe and guard.
8.
Seal all holes, plugs and conduit entrances with
weatherproof silicone sealant.
Housing
Screws
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture.
Housing Template
Back of Housing
Loop for
Tether
Junction
Box on Wall
Back of Housing
Gasket
Front of Housing
Tether
Cable
