HUNTER-PRO 32 User Manual LED Keypads
17
The system can detect movement in the protected area via its connected
detectors and sensors, therefore, it can identify no-movement hence there is
no one in the protected area.
NOTE:
The silence (no movement) timer will start counting down ONLY if no immediate
zones are opened and after the last zone to be closed is the exit delay zone (i.e.
the exit door). Any immediate zone opening will terminate the countdown.
When the system starts auto-arming, a 45 seconds ‘warning countdown’ will
start, indicating the arming countdown is to follow. Note that during the
‘warning countdown’ the keypad will beep. During the ‘warning countdown’,
any disarming code can cancel the auto-arming process.
After the ‘warning countdown’ is over, the system will begin regular arming
process, including exit delay and beeps from the keypad.
Programming Auto-Arming at Preset Time
Master Code
(LED 4 constantly ON)
(LED 4 constantly ON,
LED 1 blinks)
Time in which the system will be armed (HH:MM)
NOTE:
To cancel Auto-Arming, the Automatic Arming programming needs to be repeated, and the time
to be set as 00:00.
Programming Auto-Arming after Silence-Time is Terminated
Master Code
(LED 4 constantly ON, LED 2 blinks)
Silence Time in minutes (250 minutes max)
NOTE:
An LCD keypad is required to program silent time per partition.
Private Dialer Telephone Numbers
HUNTER-PRO 32 system has four private dialer telephone numbers.
The dialer will dial each phone number in two sets (i.e. total of 8 attempts) and
trigger an alarm warning sound, when the call is ‘picked-up’. After the warning
sound is over, the system awaits for remote-controlled commands that can be
transmitted via the telephone used by the system. The system will hang-up
