Precautions
These instructions do not replace any other precautions warnings, or instructions on the products
!
In order to prevent damage to property and/or life, one must act in accordance with the following safety
instructions :
•
The control panel has electrical connections that may cause electric shock. Make sure all voltages are disconnected before installation.
•
Warning: this equipment has no mains On/Off switch. The plug of the main power supply is intended to serve as the disconnecting device.
•
The alarm system should connect to a 230VAC/110VAC, 50/60Hz, Do not connect any other voltage to the system for fear of ignition.
•
Connect the electrical connections to the circuit according to the marking, paying attention to the correct polarity.
•
Every exposed connection that carries tension must be electrically isolated or connected to ground.
•
The connector for an external antenna t
hat transmits at a power higher than 0.5W, should be connected to the system’s ground.
•
Do not replace the system’s battery, except with a battery of the same type, in doing so this could be a risk of fire or expl
osion.
•
Disposal of used batteries must be made in accordance with local waste recovery and recycling regulations.
Overview
The CLH4x2 is designed to connect to the Hunter-Pro intruder alarm system and allows it to
communicate to the central monitoring station and the (PIMAink 3.0) app
1
via network and
cellular channels. There are two models:
•
CLH402 – 4G CAT-M
•
CLH412 – 4G CAT-1
The unit connects to the serial interface of the Hunter-Pro system.
This manual refers to both models.
Operating configuration options
Figure 1: CLH4x2 operating configurations
The channels selection is free, and the system’s owner can choose any communication
configuration according to his needs, according to the following:
•
Cellular communication only
•
Network communication only
•
Cellular and network, specifying a main channel and a backup channel
1
To support PIMAlink3.0 you need to use Hunter-Pro version 7.02/ Captain 8 version 9.0
Cellular
Network
Hunter-Pro
CLH4x2
Serial Interface
CMS
