PSEN op2.1 L/ 2.2 TMuting Set
Operating Manual PSEN op2.1 L/ 2.2 TMuting Set
1003535EN01
8
Safety regulations
Use of qualified personnel
The products may only be assembled, installed, programmed, commissioned, operated,
maintained and decommissioned by competent persons.
A competent person is someone who, because of their training, experience and current pro
fessional activity, has the specialist knowledge required to test, assess and operate the
work equipment, devices, systems, plant and machinery in accordance with the general
standards and guidelines for safety technology.
It is the company’s responsibility only to employ personnel who:
}
Are familiar with the basic regulations concerning health and safety / accident preven
tion
}
Have read and understood the information provided in this description under "Safety"
}
And have a good knowledge of the generic and specialist standards applicable to the
specific application.
Warranty and liability
All claims to warranty and liability will be rendered invalid if
}
The product was used contrary to the purpose for which it is intended
}
Damage can be attributed to not having followed the guidelines in the manual
}
Operating personnel are not suitably qualified
}
Any type of modification has been made (e.g. exchanging components on the PCB
boards, soldering work etc.).
Disposal
}
When decommissioning, please comply with local regulations regarding the disposal of
electronic devices (e.g. Electrical and Electronic Equipment Act).
Installation and wiring
Installation
}
Allocation of muting sensors to transmitter and receiver:
–
The passive muting sensor PSEN op Reflector must be installed on the transmitter
Tx.
–
The active muting sensor PSEN op Reflex must be installed on the receiver Rx.
Requirement for installing the muting sensors on the safety light grid:
}
The PSEN op muting bracket kit (Order no. 630 824)
must be attached to both units of
the safety light grid.
}
The safety light grid
must already be attached to the mounting surface.