5.4. Vice - Workpiece Clamping
The machine design allows for cutting the material under various angles without its handling. The material is permanently clamped
between the fixed gripping jaw and the moving gripping jaw . The adjustment of the required cutting angle is made by turning the
whole arm including the revolving worktable after releasing the worktable eccentric lever. When the required angle has been set
(acc. to the angle scale), secure the revolving worktable by tightening the worktable quick-clamping lever. The stop bolts serve for a
stable setting of the limit angles. The quick-clamping lever (ONLY ARG 230, 230PLUS, 240, 240PLUS and 290PLUS) enables a
comfortable and sufficient workpiece clamping. When materials of equal dimensions are being cut, it enables the releasing of the
material necessary for the feed and re-clamping only by the lever without using the handwheel.
WHEEL HANDLE
QUICK CLAMPING LEVER
(except ARG 230 Standard)
VICE MOVING BODY
FIXED JAW
WORKPIECE
CONTER NUT
ADJUSTING SCREW
OF VICE
MOVING JAW
QUICK CLAMPING LEVER
SETTING SCREW
WHEEL HANDLE
ARG 230 Standard
(without quick clamping),
ARG 230, ARG 240
“T” GROOVE
MOVING JAW
“T” GROOVE
ADJUSTING SCREW
OF VICE
CONTER NUT
FIXED JAW
WORKPIECE
VICE MOVING BODY
ARG 240 Plus, ARG 290 Plus
5.4.1. Vice side clearance setting
Models ARG 230 Standard, ARG 230, ARG 230 Plus, ARG 240, ARG 240 Plus and ARG 290 Plus only. On other models the vice is
set from the manufacturer for the complete machine lifetime.
o pen the vice to the maximum possible length
loosen lock nut M8 and screws
start tightening the first screw ( starting from the vice jaw) till you feel that you reached the vice ribbon
secure the lock nut in this position
drift the vice moving part to the same position in which previous screw was adjusted
re peat steps
continue like above till the vice is set
•
‚
ƒ
„
…
†
ƒ
,
„
,
…
‡
