4
(with 5 servos),
4
4
4 channel radio for aiplane is highly recommended for this model.
Warning
Remove the covering with proper
pressure to cut through only the covering itself.Otherwise,
cutting down into the balsa structure may weaken the
model part and cause accident.
The pre-covered film on ARF kits may wrinkle due to
variations of temperature.Smooth out as explained right.
Li-Pox4 (2200mAh)
Pre-cover the covering with clean cloth!
Start at low setting. Increase the setting if
necessary.If it is too high,you may damage
the film.
Iow setting
with cover(cloth)
Motor controller:60A
Motor (KV): 600rpm/v
Engine dimension: 42x50mm
Apply epoxy glue.
4-cycle 52-70.
We strongly recommend you use the thread lock for all the screws when you build your model.
14
"
x7
2 in Spinner
Epoxy the fixed landing gear to the main wing.
Install the nose landing gear servo.
Assemble the nose landing gear to the front gear mount.
Assemble the nose landing gear servo to the fuselage.
The sketch map once the model plane assemble completely.
Fix the nose landing gear to fuselage via TP screws.
Collar (4mm)
Collar (4mm)
Collar (4mm)
Linkage Stopper
4
TP Screw (3x12mm)
Linkage Stopper
Washer (2mm)
Washer (2mm)
Nut (2mm)
Set screw (3x4mm)
Washer (2mm)
Set screw (3x4mm)
1
1
1
1
13
70
66
68
65
67
79
