After removing from the packaging you will need to follow some basic steps to 1.
Release the safety lid.
Fill appropriate water into the water tank. Please use the provided measuring cup and
the funnel. It is recommended that you fill the tank to Max 2/3 full.
Never use de scaler, perfume or detergent in the water tank, of the appliance. as this
may damage the heating element.
Close the safety lid again.
Attach the desired accessory (nozzle, hose, scrubbing brush etc.) on the appliance:
set the accessory on the connection and press it up to the rubber sealing.
Turn the accessory in the clockwise direction, until it locks into the position.
The brush and the curved nozzle:
The brush and the curved nozzle can be assembled on the hosing, with the hose or the
straight nozzle. (Figure)
Window wiper:
Warning! Do not operate this appliance directly on cold glass.
The window wiper must be attached to the scrubbing brush. Assemble the scrubbing
brush in the appliance or the hose at first. Take off the cloth from the scrubbing brush
and connect with window wiper to the brush by the two hinges (figure). The window
wiper can be dismantles easily by loosening the hinges again.
Attach the appliance to the mains supply and the control lamp lights up.
As soon as the preheating (about 3-4 min) has terminated, the control lamp goes out.
Make sure that you do not switch the appliance on during the preheating process.
Switch the appliance on and move it slowly over the surface, which is to be cleaned. It
is recommended that the distance between the nozzle and the surface amount to 2-3
cm.
It is normal that the thermostat control light will cycle on and off during the process,
since the thermostat controls the heating element automatically.
Maintenance:
This appliance does not requires any special maintenance.
Do not try to repair the appliance. Repairs of electrical appliances must be carried our
by qualified electrician or other suitably trianed personnel.
HOW TO USE THE APPLIANCE
HOW TO USE THE APPLIANCE
5
6
