Possible cause
Appliance not plugged
correctly
Mains supply socket
damaged
Fuse blown
No water in tank
No water in tank
Too much water in the tank
Appliance overly tilted
Appliance not hot enough
Water tank still very hot
Accessory not correctly
attached
Appliance damaged
Advice
Attach the appliance
to mains supply socket again
Check the socket
Change the fuse
Fill water in tank
Fill water tank.
Empty water
Hold the appliance correctly.
Let the appliance heat up.
Let the appliance cool down
Use the funnel
Attach the accessory again
securely
Contact the customer service
Problem
Appliance does not
power up
No steam
Water runs our
from nozzle
Water boils while fill-
ing up the tank
Accessory comes
loose
Other problems
Class 1 Configuration
The wires in the mains lead are coloured in
accordance with the following code:
GREEN/YELLOW: EARTH (E)
BLUE: NEUTRAL (N)
BROWN: LIVE (L)
Class 1 Configuration
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
• The wire which is coloured GREEN &
YELLOW (or coloured GREEN) must
be connected to the terminal in the
plug which is marked with the letter “E”
or by the earth symbol .
• The wire which is coloured BLUE (or
coloured BLACK) must be connected
to the NEUTRAL terminal which is
marked with the letter “N”.
• The wire which is coloured BROWN (or
coloured RED) must be connected to
the LIVE terminal which is marked with
the letter “L”.
Always ensure that the Mains Cord is fixed
into the plug through the Cord Guard or
Cable
Clamp, (plug wiring diagram above),
and that the Cord Guard screws are
tightened to clamp the cord (outer
sheath and inner coloured wires) into
position in the plug. Make sure that the
plug top is also fitted securely.
This appliance must be protected by a
5 Amp fuse in a 13 Amp type (BS1363)
plug. Should you need to replace the
fuse, use only a 5Amp ASTA approved
BS1362 fuse (3A).
OPERATIONAL GUIDELINES
It is important to ensure the correct
Plug Adaptor is used when operating
in a country not using the UK 13 Amp
socket system. If in doubt, consult a
qualified electrician.
41mm O All
6mm Bare
15mm O All
6mm Bare
35mm O All
6mm Bare
41mm O All
6mm Bare
ELECTRICAL SAFETY
TROUBLESHOOTING
7
8
