Caution!
Shock forces may damage the built-in ceramic elements. Please avoid such forces,
and handle the units with care, otherwise the guarantee will be lost.
5. safety instructions
•
Do not open the units! There are no user serviceable parts inside and opening or
removing covers may expose you to dangerous shock hazards or other risks. Refer
all servicing to qualified service personnel.
•
Allow adequate ventilation around the units so that heat can dissipate properly. Do
not block ventilated openings or place the units near a radiator, oven or other heat
sources. Do not put anything on top of the units except things that are designed for
that purpose (e.g. actuators).
•
Do not spill any liquids into the cabinet or use the units near water.
•
Do not insert objects of any kind into the cabinet slots, as they may touch
dangerous voltage points, which can be harmful or fatal or may cause electric
shock, fire or equipment failure.
•
Do not place any heavy objects on any cables (e.g. power cords, sensor cables,
actuator cables, optical cables). Damage may cause malfunction or shock or fire!
•
Do not place the units on a sloping or unstable cart, stand or table as they may fall
or not work accurately.
•
Work with the units only in a clean and dry environment! Only specially prepared
units (e.g. actuators) can work under other conditions!
•
Please only use original parts from
piezosystem jena
.
•
piezosystem jena
does not give any warranty for damages or malfunction caused
by additional parts not supplied by
piezosystem jena
. Additional cables or
connectors will change the calibration and other specified data. This can change the
specified properties of the units and cause them to malfunction.
•
Piezo elements are sensitive systems capable of the highest positioning accuracy.
They will demonstrate their excellent properties only if they are handled correctly!
piezosystem jena GmbH
Pruessingstrasse 27 • 07745 Jena
Tel ++49 3641 66 88 – 0 • Fax –49 3641 66 88 – 66 • e-mail:
Please note that after long storage, the piezo stack in your piezo actuator
might depolarize to a certain extent. Your amplifier is equipped with a soft
start function, which, after switching on, slowly goes through the whole
motion range once. This corrects any depolarisation effects which might have
occurred.
If your application does not allow such a procedure, please tell us.
piezosystem jena has to deactivate this function.
