PD200 V6 Manual
16
Rev 1.2, Released, 05-02-2018
Bender actuators can be driven with a single bias voltage, for example 200 V, or a bipolar bias voltage, for
example ±100 V. The ±100 V bipolar configuration is shown below.
16.2
LEMO OB Cable Assembly
The LEMO 0B socket is the preferred output connector and is rated for 10 Amps RMS. The shield is directly
connected to ground, rather than Output-.
Preassembled LEMO cable assemblies are available from
www.PiezoDrive.com
The recommended cable is Belden 8451. The recommended cable preparation is shown below for solder,
and crimp-terminal plugs.
Dimension
Solder Terminals Crimp Terminals
L (Free Length)
13 mm
17 mm
S (Shield Length)
7 mm
7 mm
T (Strip Length)
3 mm
4 mm
The parts list for the LEMO 0B.302 plug are:
FGG.0B.302.CLAZ (solder terminals) or FGG.0B.302.CYCZ (crimp terminals)
FGG.0B.742.DN - collet for 3.1mm to 4mm cable
GMA.0B.035.DN - strain relief boot for 3.5mm to 3.9mm cable
The plug assembly process is:
1.
Strip the cable as above
2.
If the cable is shielded, fold the shield back over the cable
3.
Slide the strain relief, collet nut (1) and collet (3) onto the cable.
4.
Solder or crimp the conductors onto the contacts.
5.
Assemble the plug, as shown below.
+200V
0 to 200V
0V
