5. 1. 3
Electronic connection
• Electronic connection must follow up local regulations. The supply
voltage must match the details of the nameplate.
&
iiffli[IJ•
■
Danger! Electricity!
• Please must observe the following points:
❖ The electrodes must match the details on the nameplate!
❖ All the phase of device should be disconnected with electrified wire
netting.
❖ Electrical connection should according to IEC 364 (DIN VOE 0100).
For safety, device should be connected with a30 mA ground fault
circuit breaker. (Type B ground fault circuit breaker can make sure
it response to the error when it with DC fault .)
❖ The machine can not work under the damage of a broken cable. C
able and plug replacement only permitted to be carried out by cust
omer services or by experts approved by the manufacturer.
❖ Don't use a extension line! Please observe the manufacturer instr
uctions and local regulations, in case of using the extension line (M
inimum intersecting surface:1.5 mm
2
).
❖ When laying out the cable, make sure that the power cord does not
trip over people. Do not allow the cable pass through the sharp co
rners or hang in the air. Do not clamp the cable. In addition, the ca
bles must not be placed over high-temperature items and must be
protected from oil and corrosive cleaners.
❖ Don't touch the device over the cable. For connection via a mains
plug, the socket must be easily accessible during operation so that
the plug can be disconnected in the event of a fault. Don't plug the
the wet plug into socket.
5. 1. 4
Water connection
• Inferior raw material and water cause machine damaging.
Please must observe the following points:
15
