19
STEP 4
STEP 3
Coating System Assembly
>Brushes
Slide the larger brush onto the shaft followed by the supplied brush stopper.
Bring to the end and tighten both securely
Leave 100mm or
4”
between the brushes with no need for casing over the shaft. This
will allow for flexibility around bends.
Once the brushes are assembled, move on to the
Delivery Hose and Camera set up.
The larger of the two brushes will be the brush at the tip of the shaft and is used for finishing the resin. The
closest brush helps to spread the resin and stabilize the brush set during coating.
