MAINTENANCE
1.
Before performing any maintenance always check that the machine is fully turned off and
unplugged.
2.
Carefully inspect the flexible shaft and its casing on a regular basis to ensure that there are no signs of wear
and tear. Change the flexible shaft and casing as and when required.
3.
For safety and efficiency, always keep the machine and its motor, drive unit, ventilation and cooling slots clean.
4.
Check that the screws for the shaft socket are securely tightened.
5.
Check that all the bolts and screws on the machine are securely tightened.
6.
It is recommended that the oil in the bevel gear should be changed about every 12 months. Use regular oil in-
tended for gearboxes. See oil change instructions on page 17.
SERVICING THE FLEXIBLE SHAFT & ITS OUTER CASING
Prior to shipping the flexible shaft is pre
-
treated with liquid Picote Flexible Shaft Lubricant (non
-
hazardous) and
the casing replaced. Always inspect the condition of the shaft and its outer casing regularly. Also, inspect at least
every fifth working day that the shaft is properly attached under the hand guard at the machine end. If the twine
of the shaft has opened from one end to the other so that there are visible holes in the shaft, the entire shaft has
to be replaced.
Lubricant can be added between the flexible shaft and its outer casing when the shaft is removed from the
machine. In order to add lubricant the cable needs to be removed from the reel. The shaft needs to be taken out
from outer casing about 1 –
1,5
m (3
-
5ft) and lubricant needs to be added on the other side inside the cavity. No
more than 50ml/50g/1.5oz will be required for the entire shaft. Too much lubricant can cause strain on the cab-
le. After lubricant is poured, the free shaft end should be pushed through the outer casing. The shaft will push
the lubricant evenly inside the outer casing. Connect the shaft to the machine and rotate with low rotation speed
so shaft will push excess lubricant outside. Use a mat to protect the work area under the machine to prevent da-
mage to floors.
Keeping the shaft well lubricated will prolong its life span and decrease the friction caused by the shaft when it
turns around. Lower friction will reduce the load on the motor.
If preferred, the shaft can be taken out of its outer casing for lubrication.
Appropriate oil to use:
Picote Flexible Shaft Lubricant (available from your reseller)
17
Picote Solutions Oy Ltd www.picotesolutions.com
