12
STEP 1.
Log into your Sentinel Guard 2.0 as per section
Logging into the Phoenix.
STEP 2.
On the left side of the screen you will find a panel titled
POWER ALERT.
STEP 3.
To enable the power alert, click on the
ARM
button.
STEP 4.
To disable the power alert, click on the
DISARM
button.
STEP 5.
Check that the desired status is shown on the status panel above.
STEP 6.
The power failure alert is fired if the power failure alert is armed and either the power is lost or the 4G
signal of the Phoenix is lost. There is a 3
-
minute delay in the power failure alert.
STEP 1.
Up to a hundred water level sensors can be connected to the Sentinel Guard 2.0.
STEP 2.
The high water level alert is always enabled.
STEP 3.
The alert will be fired if the water level sensor detects too high a water level.
STEP 4.
The current status of the sensor can be seen on the
TEMPERATURE/WATER SENSOR
panels.
STEP 1.
Two temperature sensors can be connected
to the Sentinel Guard 2.0.
STEP 2.
Currently there is no temperature based alarm, only monitoring.
STEP 3.
The reading of the sensor(s) can be seen on the
TEMPERATURE/WATER SENSOR
panels.
