7
CONNECTORS
There are three different types of connectors in the Sentinel Guard 2.0 device: pressure, water, and power. The pres-
sure connectors and water sensor connector are located on the left side of the Sentinel 2.0 unit. The power supply
connector is located on the right side of Sentinel unit.
When connecting the power supply connector or the water sensor connector, push the connector to the socket, and
screw the threaded nut all the way in. The power and water sensor connectors have a groove and cannot be connec-
ted if misaligned. The power and water sensor connectors have protective covers that are meant to be used when
the connector is not in use.
START UP
To begin using the Sentinel Guard 2.0 device, connect it to a mains power socket using the provided cable.
Always connect the power supply provided to the Sentinel Guard 2.0unit. The unit has a back
-
up battery as well,
but it is only intended as a back
-
up for pressure measurement and to send alarm messages in the event of power
failure, and is NOT a substitute for the mains power supply.
Step 3.
Push the SIM card into the slot as shown below. Check that SIM card is properly locked into
the slot. Close the lid and test that you can connect to your Sentinel Guard 2.0 unit in
